MIL-S-22999/l(AS)
0.726/0.736 inches
Minor Diameter
Major Diameter
0.845/0.850 inches
0.072/0.077 inches
Tooth Thickness Circular
0.1571
Circular Pitch
The male starter spline shall extend .971 inches maximum
from the starter mounting flange face and shall have
.430 ± .010 inches for the overall length of the spline
teeth. A clearance hole shall be provided in the end
of the starter spline with a minimum diameter of .540 inches
and a minimum depth from the spline end of .187 inches.
Counterclockwise
Rotation viewed from anti-output shaft end:
Ports:
Conform to:
Inlet - MS33649-8; Outlet - MS33649-8
-65 to +275
Ambient temperature operating range (oF):
Exposure temperature range (°F): -103 to +275
13,000
Overspeed limit, min peak no-load speed (rpm):
4400
Inlet pressure, max at zero flow (psig):
Rated inlet pressure (psig):
3750; +50, -o
Rated outlet pressure (psig):
50; +15, -o
Rated inlet fluid temperature (°F): +275; +0, -10
Rated fluid flow (gpm): 9.0; maximum allowable flow at no-
load operation is 9.0 gpm.
Rated torque (lb-ft): 12 at 3700 psig differential pressure,
8.5 at 2750 differential pressure.
Rated drive shaft speed (rpm):
6000
Automatic shutoff control: Cutout switch shall be normally
open; it shall close upon application of hydraulic oil pressure
and open at cutout speed. The switch shall withstand a surge
current of 2 amperes at 28 volts inductive load at -65°'F.
12,000; +500, -500
Drive shaft cutout speed (rpm):
Initial calibration:
Hydraulic fluid flow, max (gpm):
Zero to max cutout drive speed: 9.0
No-load drive speed: 9.O
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business